Rion VM-83 - Command Format

54
Serial Interface
Command Format
Commands that can be used by the VM-83 consist of 3 characters (3 bytes),
usually followed by a parameter which specifies the action range of the com-
mand.
There are two types of parameters:
- Parameters for changing function settings
- Parameter for requesting data
The parameters for changing function settings are numerals, and the parameter
for requesting data is "?". In the following command description, the function
setting parameters are denoted by "n". The data output by the VM-83 in re-
sponse to the data requesting parameter are denoted by "p".
Note
The VM-83 cannot process multiple commands sent
together.
< C R >
< L F >
C o m m a n d
P a r a m e t e r
T e r m i n a t o r