55
Serial Interface
Command List
Command Function See page
RMT n1 n2 n3 Select local mode/remote mode 56
RMT? Get ID number and remote mode status 56
RNG n Set level range 56
UNT n Set measurement mode 57
DET n Set display characteristics 58
SNS n1 n2 n3 n4 Set sensitivity 58
LPF n Set low-pass filter setting 59
HPF n Set high-pass filter setting 59
CAL n Set calibration mode 60
CAL? Get calibration mode status 60
BAT? Get battery capacity status 60
DOD? Get measurement data 60
DOF n
Output instantaneous value
61
every 0.1 seconds in non-protocol mode
MAX n Set maximum hold function to On/Off 62
MAX? Get maximum hold function status 62
PEK n Set peak hold function to On/Off 62
PEK? Get peak hold function status 62
RST Reset hold value 62
CMP n Set comparator function to On/Off 62
CMP? Get comparator function status 62
CMS n1 n2 n3 n4 n5 n6 n7 Make comparator function settings 63
CMS? Get comparator function settings 63
STS? Get setting information 64
Note
Settings made via the serial interface are not memo-
rized for the resume function (see page 20).
To Next Page
Loading...
