56
Serial Interface
Commands
RMT n1 n2 n3 Select local mode/remote mode
n1 = 0 Local mode
n1 = 1 Remote mode
n2 n3 = 00 to 15, FF
Sets ID number. VM-83 specified by ID number receives
the command. FF specifies all connected VM-83.
RMT? Get ID number and remote mode status
Output data format
p1 p2 p3<EOT><CR><LF>
p1, p2 is ID number
p3 = 1 Remote mode
RNG n Set level range
Value of n is determined by INPUT SELECT switch set-
ting, measurement mode, sensitivity information, and HPF
setting, as shown in table below.
To Next Page
Loading...
