9
Controls and Features
Units indicator
The measurement unit applicable to the current measurement mode is shown
here.
m/s
2
When a piezoelectric accelerometer is used, this indicator ap-
pears during acceleration measurement.
mm/s
2
When a servo accelerometer is used, this indicator appears
during acceleration measurement.
mm/s This indicator appears during velocity measurement.
mm This indicator appears during displacement measurement.
pC/(m/s
2
) This indicator appears during sensitivity setting for the pi-
ezoelectric accelerometer.
Low-pass filter indicator
Shows the low-pass filter setting.
High-pass filter indicator
Shows the high-pass filter setting.
RMS/EQ PEAK/EQ P-P indicators
Shows the display (detection) characteristics setting.
Measurement value
Shows the current measurement value, maximum hold value, peak hold value,
menu settings, etc.
PEAK/MAX HOLD/OVER indicators
When the maximum hold function has been activated, the MAX HOLD in-
dicator is displayed.
When the peak hold function has been activated, the PEAK HOLD indicator
is displayed.
When the hold value has exceeded the measurement maximum, the OVER
indicator is displayed.
Bar graph
When the level range setting is 10000, 1000, 100, 10, 1, 0.1, or 0.01, the
indication follows the upper scale: 0, 2, 4, 6, 8, 10.
When the level range setting is 3000, 300, 30, 3, 0.3, 0.03, or 0.003, the
indication follows the lower scale: 0, 1, 2, 3.
The bar graph indication corresponds to the input level.
To Next Page
Loading...
Need help?
General
