Risco Agility 3 - Page 42

Agility 3 User Manual
Page 42
Event Message
Description
Comm OK Sounder=y
Communication OK between the Agility and Sounder Y
Comm. OK GSM
Communication OK between the Agility and GSM
Comm.OK I/O Mdl.
Communication OK between the Agility and I/O module
* Conf. alarm P=y
Confirmed alarm occurred in partition Y

Conf. Hold-Up P=y
Confirmed Hold-Up Alarm in partition Y
Confirm rs Z=xx
Restore zone confirmed alarm
* Confirm Zone=xx
Confirmed alarm occurred from zone XX
CP reset
The control panel has reset
Date set C=xx
Date defined by user no. XX
* Day Set:P=y
Daily set on partition Y
Day unset:P=y
Daily unset on partition Y
* Day part set: P=y
Daily PART setting in partition Y

Device Tmpr Omit
Device Tamper Omit
* Unset:P=y C=zz
Partition Y unset by user ZZ
* Unset: P=y KF=zz
Partition Y unset by remote control ZZ
Duress C=xx
Duress alarm from user no. XX
Enter program
Entering engineer programming from keypad or configuration
software
Exit Error Zn=xx
Exit error event from zone XX
The zone was left open at the end of the exit time
Exit program
Exiting engineer programming from keypad or configuration
software
False code
False code alarm
False restore
False code alarm restore
Fire Keypad=y
Fire alarm from wireless keypad Y
Fire main KP
Fire alarm from
Fire ok Zone=xx
Fault restore in fire zone no. XX
Fire Flt Zn=xx
Fault in fire zone no. XX
* Fire Zone=xx
Fire alarm in zone no. XX
Foil ok Z=xx
Restore in foil (Day) zone no. XX
Foil Zone=xx
Fault in foil (Day) zone no. XX
Forced P=y
Partition Y is force set
Found Zone=xx
Wireless zone found, zone no. XX
* Gas Alarm Zn=xx
Gas (natural gas) alert from zone XX defined as a gas detector
Gas Rst. Zn=xx
Gas (natural gas) alert restored from zone XX defined as a gas
detector
GSM:IP OK
IP connection OK
GSM:IP Fault
IP address is incorrect
GSM:Mdl comm.OK
Communication between the GSM/GPRS Module and the Agility is
OK