GX-2003 Operator’s Manual Display Mode • 35
The STEL reading is the average reading during the last 15 minutes.
Date/Time/Battery Charge Screen
The date/time/battery charge screen displays the current date, time,
and battery charge level. If the battery icon is fully filled in black, then
the batteries are fully charged.
Clear Data Logger Screens
CAUTION:Once you clear the data logger, you cannot retrieve any data
previously stored in the data logger.
NOTE: The GX-2003 does not log data during the first minute of
operation after being turned on, so this screen will not appear
during the first minute of operation after start up.
The clear data logger screens allow you to clear the data logger
storage. (Press and release the DISPLAY(ADJ) button to go to the
Remaining Log Time screen). You can set the GX-2003 to overwrite the
oldest data when the data log is full. See “Updating the Datalog
Overwrite Setting” on page 63.
To clear the data log:
1. With the above screen displayed, press and release the ▲AIR
button.
A confirmation message displays.
TWA STEL
H2S 0.0 0.0ppm
CO 0 0ppm
21:09
Sept/23/’03
20:34
BATTERY:
CLEAR DATA
LOGGER
YES :AIR
NO :DISPLAY
21:09
ARE YOU SURE ?
YES :AIR
NO :DISPLAY
21:09
To Next Page
Loading...
Need help?
General
