Changing Data Logging Parameters • 55
Changing Data Logging
Parameters
To make changes to parameters stored in the GX-2003, use the
Set window of the GX-2003 Data Logging Software. Follow the
steps below to make these changes.
1. Launch the GX-2003 Data Logging Software.
2. .Connect a GX-2003 to the software. See “Downloading
Data from the GX-2003” on page 23, instruction 1 through
instruction 3, to connect an instrument to the software.
3. Once the connection is made, the Complete Download,
Instrument Information, and Power Off download
commands will be selectable. Click the Instrument
Information download command to retrieve the instrument
information from the GX-2003. If you wish to download data
before making changes, click Complete Download instead
of Instrument Information.
4. Click the Set button to display the Set window. Use the GX-
2003 Status frame and the Gas/Sensor frame to change
parameters stored in the GX-2003.
Figure 38: Set Window
Click to
upload
changes to
GX-2003
To Next Page
Loading...
