58 • Overview GX-2003 Operator’s Manual
Chapter 6: Setup Mode
Overview
This chapter describes the GX-2003 in Setup Mode. In Setup Mode,
you can:
• update alarm point settings
• turn the lunch break function on or off
• update the alarm latching setting
• update the alarm silence setting
• turn the confirmation beep on or off
• update the data logging interval time setting
• update the data logger overwrite setting
• update the date and time
• update the calibration interval setting
• turn the calibration time remaining function on or off
• update the calibration expired action setting
• adjust the display contrast
• update the GX-2003’s serial number
• turn the user ID/station ID function on or off
• perform an auto calibration
• perform a single calibration
• update the LCD back light time setting
• turn the password function on or off
• turn bar hole and leak check modes on or off
• set the bar hole measurement time
The GX-2003 is factory-set to suit most applications. Update settings
in Setup Mode only if required for your specific application.
To Next Page
