72 • Using Setup Mode GX-2003 Operator’s Manual
6. Repeat steps 4 and 5 to select the remaining characters. When you
press and release the POWER ENTER button to enter the last
number, the password is saved and you return to the main menu.
Turning LB Mode Display On or Off
With LB MODE DISPLAY set to ON, the Mode Select Screen appears
when the unit is turned on.
With LB MODE DISPLAY set to OFF, the Mode Select Screen does
not appear when the unit is turned on and the unit goes into Normal
Mode after the start up sequence.
This setting is factory set to OFF when a unit is shipped unless the
instrument is ordered for bar hole measurement or leak checking use.
1. From the main menu, place the cursor next to the SET LB MODE
DISPLAY menu item. Press and release the POWER ENTER
button.
2. Use the ▲AIR or (SHIFT)▼ button to display the desired setting.
3. Press and release the POWER/ENTER button to save the setting
and return to the main menu.
Setting the Bar Hole Measurement Time
This setting indicates the length of time the unit will sample when a
bar hole measurement is initiated in Bar Hole Mode. It can to set to 30
(factory set), 45, or 60 seconds.
1. From the main menu, place the cursor next to the B.H. MEASURE
TIME menu item. Press and release the POWER ENTER button.
2. Use the ▲AIR or (SHIFT)▼ button to display the desired setting.
3. Press and release the POWER ENTER button to save the setting
and return to the main menu.
SET LB MODE DISPLAY
OFF
21:09
SET B.H. MEAS TIME
30 SEC
21:09
To Next Page
Loading...
Need help?
General
