Commissioning and Maintenance
34 © robatherm
Disassembly/Reassembly of Coils
Shutdown the coil, and drain it.
Remove connection pipe and hydraulic set.
Remove the coil’s front panel (use Torx T25 or screw driver).
(Cooling coil: Remove the condensate backflow preventer sheet.)
Pull out coil to the front side, support coil if necessary.
Check sealings, replace worn out parts.
Reassemble in reverse order.
Pos: 49 /Layout/Seite numbruch @ 0\mod_12566286 15637_0.doc @ 2284 @
To Next Page
Loading...