34
Examples of RAINS statuses:
Dry desiccants in the xture arm Desiccants in the xture arm partially
saturated with water
Desiccants in the xture arm fully
saturated with water
Silica gel desiccants in the xture arm are saturated with water and should be replaced.
After replacing them, reset the item MAX WET.
It is not necessary to replace silica gels desiccants in plastic boxes in the xture head and base. These desiccants
should be checked (and replaced if it is needed) at removing head or base covers, e.g. at gobo replacement
or some service intervention.
Sensors Info - The menu items shows you current conditions in the xture head (at pressure sensor): temper-
ature, relative humidity and pressure.
DMX Values - The menu items allows you to read DMX values of each channel received by the xture.
Wireless State - The menu serves for reading of the wireless operation status.
Unlink Wireless Adaptor - The item serves for unlinking the xture from a DMX transmitter.
If the wireless module is not installed in the xture, message" Wireless Module Not Installed" will appear.
Power Channel State - Select this item to see current setting of the functions, which can be set by menu items
in "Personality" as well as by DMX command at channel "Power/Special functions".
Colour Functions State - Select this item to see current setting of the colour functions, which can be set by
menu items in "Personality" as well as by DMX command at channel "Colour functions".
Software Version - Select this item to read the software version of the xture processors:
Display System - A display processor on the display board in the xture base
Module M - a Pan/Tilt processor
Module L 1 - a LEDs control processor 1
Module L 2 - a LEDs control processor 2
Module C1 - a Colour wheel 1 control processor
Module C2 - a Colour wheel 2 control processor
Module G 1 - a Rot. gobo wheel control processor
Module G 2 - a Rot. gobo wheel control processor
Module F-A -a Framing shutters control processor
Module F-B - a Framing shutters/Iris control processor
Module O - a Focus/Zoom/Light frost control processor
To Next Page
Loading...
