Rockwell Automation Publication 2198-UM005C-EN-P - February 2022 185
Appendix B
Upgrade Kinetix 5300 Drive Firmware
This appendix provides procedures to upgrade your Kinetix® 5300 drive
firmware.
You can upgrade your Kinetix 5300 drive firmware by using either of these two
methods:
• ControlFLASH Plus™ software
• ControlFLASH™ software
To upgrade drive firmware, you must configure a path to your drive, select the
drive module to upgrade, and complete the firmware upgrade procedure.
Before You Begin For firmware upgrades, you must use the software revisions that are shown in
for EtherNet/IP™ networks.
Topic Page
Before You Begin 185
Upgrade Your Firmware 187
Verify the Firmware Upgrade 195
We recommend that you use ControlFLASH Plus software for firmware upgrades. See
the ControlFLASH Plus Quick Start Guide, publication CFP-QS001
, for more
information.
Table 91 - Kinetix 5300 System Requirements
Description Revision
Studio 5000 Logix Designer® application 33.00.00 or later
RSLinx® software
(1)
(1) Only required when using ControlFLASH software.
4.20.00 or later
FactoryTalk® Linx software
(2)
(2) Only required when using ControlFLASH Plus software.
6.20.00 or later
ControlFLASH software kit
(3)
(3) Download the ControlFLASH software kit from the Product Compatibility and Download Center at: rok.auto/pcdc. For more
ControlFLASH software information (not Kinetix 5300 specific), refer to the ControlFLASH Firmware Upgrade Kit User Manual,
publication 1756-UM105
.
15.03.00 or later
ControlFLASH Plus software kit
(3)
3.01 or later
To Next Page
Loading...
Need help?
General
