136 Rockwell Automation Publication 7000L-UM301F-EN-P - March 2020
Chapter 3 Operator Interface
Figure 136 - Save Operation
To confirm the operation, press the [F8] key to proceed, or the [F9] key to abort.
Saving the data will overwrite the previously stored data in the NVRAM.
Load
The changes that you stored in NVRAM are automatically used each time the
drive is powered up. If you make changes to the data in the drive (without saving)
and then wish to use the previously stored data, press the [F4] key (Figure 137
).
Figure 137 - Load Operation
To confirm the operation, press the [F8] key to proceed, or the [F9] key to abort.
Loading the data will overwrite the data currently being used by the drive.
To Next Page
Loading...
