Rockwell Automation ics triplex AADvance User Manual

Document: 553632
(ICSTT-RM448_EN_P) Issue: 08:
2-1
This chapter lists important information the reader should consider before starting to
build the system. It includes preparatory information necessary for a successful
installation.
In This Chapter
In This ChapterIn This Chapter
In This Chapter
Required Tools Standard AADvance ............................................................. 2-1
Test Equipment ................................................................................................... 2-2
System Installation Environment ..................................................................... 2-2
Specifying an Enclosure...................................................................................... 2-2
Controller Design Considerations for Heat and Cooling ........................ 2-7
System Power Requirements ........................................................................... 2-7
Power Arrangements for Field Devices ........................................................ 2-9
Estimate Module Supply Power Dissipation and Field Loop Power
Dissipation ............................................................................................................ 2-9
Estimate AADvance Controller Weight ..................................................... 2-10
Estimating Centre of Gravity Information .................................................. 2-10
Design Considerations for Electrical Grounding ...................................... 2-11
Power Supply Requirements .......................................................................... 2-11
Specifying the Workstation PC ..................................................................... 2-12
Design Considerations for Maintenance Activities
................................
...
2
-
12
Required Tools Standard AADvance
Required Tools Standard AADvanceRequired Tools Standard AADvance
Required Tools Standard AADvance
The installation and maintenance of the AADvance controller requires the following
tools:
Stand
StandStand
Standard Tools
ard Toolsard Tools
ard Tools
 Screwdriver, flat 0.8 x 9.0mm (1/25 c 3/8 inch), for the module clamp screws and
blanking covers
 Screwdriver, cross head number 0, for battery cover on T9110 processor module
 screwdriver, flat 0.8 x 4.0mm (1/25 x 5/32 inch), for locking screws on extension
cables
 Torque screwdriver, flat 0.6 x 3.0 mm(1/40 x 1/8 inch, for dc power wiring
terminals
 Torque screwdriver, flat 0.4 x 2.0mm (1/64 x 5/64), for field wiring terminals
 2 x wrench, open end, 10mm, for ground stud nuts
 Allen key (hex wrench), 2.5mm, for plug and sockets assemblies used with
extension cables
Special Tool
Special ToolSpecial Tool
Special Tool
 Long nosed pliers to remove the fuses on termination assemblies.
Chapter
Chapter Chapter
Chapter
2
22
2
Before You Begin
Before You BeginBefore You Begin
Before You Begin

Rockwell Automation ics triplex AADvance Specifications

General

Brand	Rockwell Automation
Model	ics triplex AADvance
Category	Controller
Language	English