FSE Manuals
1065.6016.12 0.1 E-1
Contents of Manuals for Spectrum Analyzer FSE
Operating Manual FSE
The operating manual describes the following models and options:
• FSEA20/30 9kHz/20 Hz to 3,5 GHz
• FSEB20/30 9kHz/20 Hz to 7 GHz
• FSEM20/30 9kHz/20 Hz to 26,5 GHz
• FSEK20/30 9kHz/20 Hz to 40 GHz
• Option FSE-B3 TV Demodulator
• Option FSE-B5 FFT Filter
• Option FSE-B8/9/10/11 Tracking Generator
• Option FSE-B13 1 dB Attenuator
• Option FSE-B15 DOS Controller (Id.-Nr: 1073.5696.02/.03)
• Option FSE-B15 Windows NT Controller (Id.-Nr.: 1073.5696.06)
• Option FSE-B16 Ethernet Adapter
• Option FSE-B17 Second IEC/IEEE Bus Interface
Options FSE-B7, Vector Signal Analysis, and FSE-B21, External Mixer Output, are described in se-
parate manuals.
The present operating manual contains comprehensive information about the technical data of the
instrument, the setup and putting into operation of the instrument, the operating concept and controls
as well as the operation of the FSE via the menus and via remote control. Typical measurement
tasks for the FSE are explained using the functions offered by the menus and a selection of program
examples.
In addition the operating manual gives information about maintenance of the instrument and about
error detection listing the error messages which may be output by the instrument. It is subdivided into
2 volumes containing the data sheet plus 9 chapters:
Volume 1
The data sheet informs about guaranteed specifications and characteristics of the instrument.
Chapter 1 describes the control elements and connectors on the front and rear panel as
well as all procedures required for putting the FSE into operation and integra-
tion into a test system.
Chapter 2 gives an introduction to typical measurement tasks of the FSE which are ex-
plained step by step.
Chapter 3 describes the operating principles, the structure of the graphical interface and
offers a menu overview.
Chapter 4 forms a reference for manual control of the FSE and contains a detailed de-
scription of all instrument functions and their application.
Chapter 10 contains an index for the operating manual.
Volume 2
Chapter 5 describes the basics for programming the FSE, command processing and the
status reporting system.
Chapter 6 lists all the remote-control commands defined for the instrument. At the end of
the chapter a alphabetical list of commands and a table of softkeys with com-
mand assignment is given.
Chapter 7 contains program examples for a number of typical applications of the FSE.
Chapter 8 describes preventive maintenance and the characteristics of the instrument’s
interfaces.
Chapter 8 gives a list of error messages that the FSE may generate.
Chapter 9 contains a list of error messages.
Chapter 10 contains an index for the operating manual.
To Next Page
Loading...
