Rohde & Schwarz FSEA20 - INPUT Key

Command Assignment - Signal Analysis FSE
1065.6016.12 6.262 E-16
RANGE
LOG ...
:DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y:SPACing LOGarithmic;
:DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y[:SCALe] <num_value>
LINEAR/%
:DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y:SPACing PERCent
LINEAR/dB
:DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y:SPACing LINear
LOG MANUAL
:DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y:SPACing LOGarithmic;
:DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y[:SCALe] <num_value>
GRID
ABS/REL
:DISPlay[:WINDow<1|2>]:TRACe<1...4>:Y[:SCALe]:MODE ABSolute|RELative
INPUT Key
INPUT
RF ATTEN
MANUAL
:INPut<1|2>:ATTenuation <num_value>
ATTEN AUTO
NORMAL
:INPut<1|2>:ATTenuation:AUTO:MODE NORMal;
:INPut<1|2>:ATTenuation:AUTO ON
ATTEN AUTO
LOW NOISE
:INPut<1|2>:ATTenuation:AUTO:MODE LNOise;
:INPut<1|2>:ATTenuation:AUTO ON
ATTEN AUTO
LOW DIST
:INPut<1|2>:ATTenuation:AUTO:MODE LDIStortion;
:INPut<1|2>:ATTenuation:AUTO ON
MIXER
LEVEL
:INPut<1|2>:MIXer <num_value>
ATTEN STEP
1dB / 10dB
:INPut<1|2>:ATTenuation:STEPsize 1dB |10dB (with option FSE-B13 only)
INPUT
SELECT
--
RF INPUT
50 OHM
:INPut<1|2>:IMPedance 50
RF INPUT
75 OHM/RAM
:INPut<1|2>:IMPedance:CORRection RAM
RF INPUT
75OHM/RAZ
:INPut<1|2>:IMPedance:CORRection RAZ