Rohde & Schwarz FSEA20 - Sense:filter Subsystem

SENSe Subsystem FSE
1065.6016.12 6.190 E-16
SENSe:FILTer Subsystem
The SENSe:FILTer subsystem selects the filters in the video signal path.This subsystem is active only in
the Vector Signal Analysis mode (option FSE-B7).
COMMAND PARAMETERS UNIT COMMENT
[SENSe<1|2>]
:FILTer
:HPASs
[:STATe]
:FREQuency
<Boolean>
<numeric_value>
--
HZ
Vector Signal Analyzer
:LPASs
[:STATe]
:FREQuency
:CCITt
[:STATe]
:CMESsage
[:STATe]
:DEMPhasis
[:STATe]
:TCONstant
:LINK
<Boolean>
<numeric_value>
<Boolean>
<Boolean>
<Boolean>
<numeric_value>
DISPlay | AUDio
--
HZ | PCT
--
--
S
Vector Signal Analyzer
:[SENSe<1|2>:]FILTer:HPASs[:STATe] ON | OFF
This command activates the high-pass filter in the AF-branch for analog demodulation.
Example: ":FILT:HPAS ON"
Features: *RST value: OFF
SCPI: conforming
Mode: VA-A
:[SENSe<1|2>:]FILTer:HPASs:FREQuency 30 Hz | 300 Hz
In the Vector Signal Analysis mode with analog demodulation, this command defines the frequency
limit of the high-pass filter in the AF-branch. For REAL TIME ON absolute frequencies are entered,
for REAL TIME OFF, the frequencies are entered relative to the demodulation bandwidth.
Example: ":FILT:HPAS:FREQ 300HZ"
Features: *RST value: - (STATe = OFF)
SCPI: conforming
Mode: VA-A
:[SENSe<1|2>:]FILTer:LPASs[:STATe] ON | OFF
This command activates the low-pass filter in the AF-branch with analog demodulation.
Example: ":FILT:LPAS ON"
Features: *RST value: OFF
SCPI: conforming
Mode: VA-A
On switching to ON, a bandwidth of 3 kHz for REAL TIME ON and a bandwidth of 5 PCT for REAL
TIME OFF is set automatically.