UNIT Subsystem FSE
1065.6016.12 6.240 E-16
UNIT Subsystem
The UNIT subsystem is used to switch the basic unit of setting parameters. In split screen mode, a
distinction is made between UNIT1 (screen A) and UNIT2 (screen B).
COMMAND PARAMETERS UNIT COMMENT
UNIT<1|2>
:POWer
:PROBe
DBM | DBPW | WATT |
DBUV | DBMV | VOLT |
DBUA | AMPere
V | W | DB | PCT | UNITLESS |
DBUV_MHZ | DBMV_MHZ |
DBUA_MHZ | DBUV_M | DBUA_M |
DBUV_MMHZ | DBUA_MMHZ
<Boolean>
:UNIT<1|2>:POWer DBM | DBPW | WATT | DBUV | DBMV | VOLT | DBUA | AMPere | V | W | DB |
PCT | UNITLESS | DBUV_MHZ |DBMV_MHZ | DBUA_MHZ | DBUV_M |
DBUA_M | DBUV_MMHZ | DBUA_MMHZ
This command selects the default unit for input and output.
Example: ":UNIT:POW DBUV"
Features: *RST value: DBM
SCPI: conforming
Mode: A
:UNIT<1|2>:PROBe ON | OFF
This command determines whether the coding of a probe which is connected to the front panel is
taken into consideration (ON) or not (OFF).
Example: ":UNIT:PROB OFF"
Features: *RST value: ON
SCPI: device-specific
Mode: A
To Next Page
Loading...
