Rohde & Schwarz FSEA20 - CONFIGURATION Key Group

FSE Command Assignment - General Device Settings
1065.6016.12 6.277 E-16
CONFIGURATION Key Group
MODE
The submenus are described at the corresponing operating mode.
ANALYZER
:INSTrument<1|2>[:SELect] SANalyzer
:INSTrument<1|2>:NSELect 1
TRACKING
GENERATOR
OUTPut[:STATe] ON | OFF
VECTOR
ANALYZER
:INSTrument<1|2>[:SELect] ADEMod | DDEMod
:INSTrument<1|2>:NSELect 2 | 3
TV DEMOD
:[SENSe<1|2>:]TV[:STATe] ON | OFF
GSM MS
ANALYZER
:INSTrument<1|2>[:SELect] MGSM
:INSTrument<1|2>:NSELect 5
GSM BTS
ANALYZER
:INSTrument<1|2>[:SELect] BGSM
:INSTrument<1|2>:NSELect 4
SETUP
TRANSDUCER
--
TRANSDUCER
FACTOR
:[SENSe<1|2>:]CORRection:TRANsducer:SELect <name>
:[SENSe<1|2>:]CORRection:TRANsducer[:STATe] ON | OFF
TRANSDUCER
SET
:[SENSe<1|2>:]CORRection:TSET:SELect <name>
:[SENSe<1|2>:]CORRection:TSET[:STATe] ON | OFF
EDIT TRD
FACTOR
:[SENSe<1|2>:]CORRection:TRANsducer:SCALing LINear|LOGarithmic
:[SENSe<1|2>:]CORRection:TRANsducer:COMMent <string>
TRD FACTOR
NAME
:[SENSe<1|2>:]CORRection:TRANsducer:SELect <name>
TRD FACTOR
UNIT
:[SENSe<1|2>:]CORRection:TRANsducer:UNIT <string>
TRD FACTOR
VALUES
:[SENSe<1|2>:]CORRection:TRANsducer:DATA <freq>,<level>..
INSERT
LINE
no corresponding IEC/IEEE-bus command
DELETE
LINE
no corresponding IEC/IEEE-bus command
SAVE TRD
FACTOR
automatically executed during IEC/IEEE-bus operationh
EDIT TRD
SET
:[SENSe<1|2>:]CORRection:TSET:BREak ON | OFF
:[SENSe<1|2>:]CORRection:TSET:COMMent <string>
TRANSD SET
NAME
:[SENSe<1|2>:]CORRection:TSET:SELect <name>
TRANSD SET
UNIT
:[SENSe<1|2>:]CORRection:TSET:UNIT <string>