Rohde & Schwarz FSEA20 - Page 335

Command Assignment - General Device Settings FSE
1065.6016.12 6.278 E-16
TRANSD SET
RANGES
:[SENSe<1|2>:]CORRection:TSET:RANGe<1...10> <freq>,<freql>,<name>..
INSERT
LINE
no corresponding IEC/IEEE-bus command
DELETE
LINE
no corresponding IEC/IEEE-bus command
SAVE TRD
SET
automatically executed during IEC/IEEE-bus operationh
NEW
FACT/SET
see EDIT TRD FACTOR or EDIT TRD SET
DELETE
FACTOR/SET
:[SENSe<1|2>:]CORRection:TRANsducer:DELete
:[SENSe<1|2>:]CORRection:TSET:DELete
OPTIONS
no corresponding IEC/IEEE-bus command
REFERENCE
INT/EXT
:[SENSe<1|2>:]ROSCillator:SOURce INTernal|EXTernal
EXT REF
FREQUENCY
:[SENSe<1|2>:]ROSCillator:EXTernal:FREQuency <num_value>
SERVICE
--
INPUT RF
:DIAGnostic:SERVice:INPut[:SELect] RF
INPUT CAL
:DIAGnostic:SERVice:INPut[:SELect] CALibration
NOISE
SOURCE
:DIAGnostic:SERVice:NSOurce ON | OFF
REFERENCE
ADJUST
--
REFERENCE
:[SENSe<1|2>:]ROSCillator:[INTernal:]TUNe <num_value>
REFERENCE
PROG
:[SENSe<1|2>:]ROSCillator:[INTernal:]TUNe:SAVe
SERVICE
FUNCTION
:DIAGnostic:SERVice:FUNCtion <num_value>,<num_value>...
ENTER
PASSWORD
:SYSTem:PASSword[:CENable] <string>
GENERAL
SETUP
--
GPIB
ADDRESS
:SYSTem:COMMunicate:GPIB[:SELF]:ADDRess 0...30
USER PORT
A/B
:INPut<1|2>:UPORt<1|2>[:VALue]?
:INPut<1|2>:UPORt<1|2>:STATe ON | OFF
:OUTPut<1|2>:UPORt<1|2>:STATe ON | OFF
:OUTPut<1|2>:UPORt<1|2>[:VALue] <Binary>