FSE Switchover to Remote Control
1065.6016.12 5.5 E-16
Limitations
The following limitations apply if the unit is remote-controlled via the RS-232-C interface:
− No interface messages, some control codes are defined (see chapter 8).
− Only the Common Commands *OPC? can be used for command synchronization, *WAI and *OPC
are not available.
− Block data cannot be transmitted.
When Windows NT is booted, data are output via the COM interface because of automatic external
device recognition. Therefore, it is recommended to clear the input buffer of the controller before remote
operation of the instrument via the COM interface.
To Next Page
Loading...
