Rohde & Schwarz FSEA20 - TRIGGER Key Group - Analog Demodulation

Command Assignment - Vector Signal Analysis FSE
1065.6016.12 6.296 E-16
SLOPE
POS NEG
:TRIGger<1|2>[:SEQuence]:SLOPe POSitive|NEGative
MEAS ONLY
IF SYNC’D
:[SENSe<1|2>:]DDEMod:SEARch:SYNC:MONLy ON | OFF
FIND BURST
ON OFF
:[SENSe<1|2>:]DDEMod:SEARch:PULSe:STATe ON | OFF
FIND SYNC
ON OFF
:[SENSe<1|2>:]DDEMod:SEARch:SYNC:STATe ON | OFF
SYNC
OFFSET
:[SENSe<1|2>:]DDEMod:SEARch:SYNC:OFFSet <num_value>
SYNC
PATTERN
--
SELECT
PATTERN
:[SENSe<1|2>:]DDEMod:SEARch:SYNC:SELect <pattern_name>
NEW SYNC
PATTERN
:[SENSe<1|2>:]DDEMod:SEARch:SYNC:PATTern <string>
NAME
:[SENSe<1|2>:]DDEMod:SEARch:SYNC:NAME <pattern_name>
COMMENT
:[SENSe<1|2>:]DDEMod:SEARch:SYNC:COMMent <string>
VALUE
:[SENSe<1|2>:]DDEMod:SEARch:SYNC:DATA <string>
:[SENSe<1|2>:]DDEMod:SEARch:SYNC:PATTern <string>
(the pattern is set in the instrument and automatically saved under the name remote.pat)
SAVE
PATTERN
automatically executed during IEC/IEEE-bus operation (see command
[SENSe<1|2>:]DDEMod:SEARch:SYNC:PATTern <string>)
EDIT SYNC
PATTERN
:[SENSe<1|2>:]DDEMod:SEARch:SYNC:PATTern <string>
DELETE
PATTERN
:[SENSe<1|2>:]DDEMod:SEARch:SYNC:DELete
TRIGGER Key Group - Analog Demodulation
TRIGGER
FREE RUN
:TRIGger<1|2>[:SEQuence]:SOURce IMMediate
VIDEO
:TRIGger<1|2>[:SEQuence]:SOURce VIDeo
:TRIGger<1|2>[:SEQuence]:LEVel:VIDeo <num_value>
EXTERN
:TRIGger<1|2>[:SEQuence]:SOURce EXTernal
:TRIGger<1|2>[:SEQuence]:LEVel[:EXTernal] -5.0...+5.0V
AF SIGNAL
:TRIGger<1|2>[:SEQuence]:SOURce AF
:TRIGger<1|2>[:SEQuence]:LEVel:AF -120...+120PCT
SLOPE
POS/NEG
:TRIGger<1|2>[:SEQuence]:SLOPe POSitive|NEGative
TRIGGER
OFFSET
:TRIGger<1|2>[:SEQuence]:HOLDoff <num_value>