Rohde & Schwarz FSEA20 - Page 158

FSE FETCh-Subsystem
1065.6016.12 6.101 E-16
FETCh Subsystem
The FETCh subsystem contains commands for reading out results of complex measurement tasks like
those provided by options GSM BTS Analyzer, FSE-K11, or GSM MS Analyzer, FSE-K10. The FETCh-
subsystem is closely linked to the functions of the CONFigure and READ-subsystems, where the
measurement sequences are configured, the measurements are started and their results are queried.
FETCh:BURSt Subsystem
This subsystem provides the commands for reading out results of measurements in the GSM BTS
(option FSE-K11) or GSM MS (option FSE-K10) Analyzer mode, which are performed on individual
bursts (Carrier Power, Phase/Frequency Error) without starting the measurement by themselves.
COMMAND PARAMETERS UNIT COMMENT
FETCh
:BURSt
:PERRor
:RMS
:STATus?
:AVERage?
:MAXimum?
:PEAK
:STATus?
:AVERage?
:MAXimum?
:FERRor
:STATus?
:AVERage?
:MAXimum?
:POWer
[:IMMediate]?
:ALL?
:MACCuracy
:RMS
:STATus?
:AVERage?
:MAXimum?
:PEAK
:STATus?
:AVERage?
:MAXimum?
:OSUPpress
:STATus?
:AVERage?
:MAXimum?
:PERCentile
:STATus?
:AVERage?
:MAXimum?
:FREQuency
:STATus?
:AVERage?
:MAXimum?
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
Option FSE-K11 or FSE-K10
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only
query only