INPut Subsystem FSE
1065.6016.12 6.128 E-16
:INPut<1|2>:ATTenuation:STEPsize 1dB | 10dB
This command defines the attenuator stepsize.
Example: ":INP:ATT:STEP 1dB"
Features: *RST value: 10dB
SCPI: device-specific
Mode: A, VA, BTS, MS
This command is only available in conjunction with option FSE-B13, 1-dB attenuator.
:INPut<1|2>:UPORt<1|2>[:VALue]?
This command queries the control lines of the user ports.
Example: ":INP:UPOR2?"
Features: *RST value: -
SCPI: device-specific
Modes: A, VA, BTS, MS
This command is a query command which is why it is not assigned an *RST value.
:INPut<1|2>:UPORt<1|2>:STATe ON | OFF
This command toggles the control lines of the user ports between INPut and OUTPut.
Example: ":INP:UPOR2:STAT ON"
Features: *RST value: ON
SCPI: device-specific
Modes: A, VA, BTS, MS
With ON, the user port is switched to INPut, with OFF to OUTPut.
:INPut<1|2>:IMPedance 50 | 75
This command sets the nominal input impedance of the instrument.
Example: ":INP:IMP 75"
Features: *RST value: 50
SCPI: conforming
Modes: A, VA, BTS, MS
Switching the input impedance to 75 Ω includes the matching elements RAM or RAZ selected by the
command INPut:IMPedance:CORRection.
To Next Page
Loading...
