FSE SENSe Subsystem
1065.6016.12 6.169 E-16
:[SENSe<1|2>:]BANDwidth|BWIDth:VIDeo 1Hz to 10MHz
This command defines the instrument’s video bandwidth.
Example: ":BAND:VID 10kHz"
Features: *RST value: - (AUTO is set to ON)
SCPI: conforming
Mode: A
The values for the video bandwidth are rounded in 1 | 2 | 3 | 5 steps.
:[SENSe<1|2>:]BANDwidth|BWIDth:VIDeo:AUTO ON | OFF
This command either automatically couples the instrument’s video bandwidth to the resolution
bandwidth or cancels the coupling.
Example: ":BAND:VID:AUTO OFF"
Features: *RST value: ON
SCPI: conforming
Mode: A
:[SENSe<1|2>:]BANDwidth|BWIDth:VIDeo:RATIO 0.001to 1000 | SINe | PULSe | NOISe
This command defines the ratio video bandwidth (Hz) / resolution bandwidth (Hz).
Parameter: The parameters SINe, PULSe and NOISe may be used as synonyms for the
following values:
SINe: 1
PULSe: 10
NOISe: 0.1
Example: ":BAND:VID:RAT 10"
Features: *RST value: - (AUTO is set to ON)
SCPI: conforming
Modes: A, VA
The ratio to be entered is reciprocal to the ratio RBW/VBW used in manual control.
:[SENSe<1|2>:]BANDwidth|BWIDth:DEMod
5kHz to 200kHz (Real Time on) | 5kHz to 5MHz (Real Time off)
This command defines the demodulation bandwidth of the instrument for analog demodulation.
Example: ":BAND:DEM 100KHZ"
Features: *RST value: 100KHZ
SCPI: device-specific
Mode: VA-A
The values for the demodulation bandwidth are rounded in steps of 1 | 2 | 3 | 5.
To Next Page
Loading...
