Rohde & Schwarz FSEA20 - Page 329

Command Assignment - Signal Analysis FSE
1065.6016.12 6.272 E-16
LINE
:TRIGger<1|2>[:SEQuence]:SOURce LINE
EXTERN
:TRIGger<1|2>[:SEQuence]:SOURce EXTernal
:TRIGger<1|2>[:SEQuence]:LEVel[:EXTernal] -5.0...+5.0V
RF POWER
:TRIGger<1|2>[:SEQuence]:SOURce RFPower
TRIGGER
DELAY
:TRIGger<1|2>[:SEQuence]:HOLDoff <num_value>
SLOPE
POS/NEG
:TRIGger<1|2>[:SEQuence]:SLOPe POSitive|NEGative
SWEEP
CONTINUOUS
SWEEP
:INITiate<1|2>:CONTinuous ON; :INITiate<1|2>[:IMMediate]
SINGLE
SWEEP
:INITiate<1|2>:CONTinuous OFF; :INITiate<1|2>[:IMMediate]
SWEEP TIME
AUTO
:[SENSe<1|2>:]SWEep:TIME:AUTO ON | OFF
SWEEP TIME
MANUAL
:[SENSe<1|2>:]SWEep:TIME <num_value>
SWEEP
COUNT
:[SENSe<1|2>:]SWEep:COUNt <num_value>
GAP SWEEP
ON/OFF
:[SENSe<1|2>:]SWEep:GAP ON | OFF
GAP SWEEP
SETTINGS
--
TRIGGER
LEVEL
:TRIGger<1|2>[:SEQuence]:LEVel:VIDeo <num_value>
PRE TRIGGER
:[SENSe<1|2>:]SWEep:GAP:PRETrigger <num_value>
TRG TO
GAP TIME
:[SENSe<1|2>:]SWEep:GAP:TRGTogap <num_value>
GAP
LENGTH
:[SENSe<1|2>:]SWEep:GAP:LENGth <num_value>
GATE
ON / OFF
:[SENSe<1|2>:]SWEep:EGATe ON | OFF
GATE
SETTINGS
--
GATE
LEVEL
:[SENSe<1|2>:]SWEep:EGATe:LEVel <num_value>
GATE MODE
LEVEL/EDGE
:[SENSe<1|2>:]SWEep:EGATe:TYPE LEVel | EDGE
GATE POL
POS/NEG
:[SENSe<1|2>:]SWEep:EGATe:POLarity POSitive | NEGative
GATE
DELAY
:[SENSe<1|2>:]SWEep:EGATe:HOLDoff <num_value>