Common Commands FSE
1065.6016.12 6.6 E-16
*OPT?
OPTION IDENTIFICATION QUERY queries the options included in the instrument and returns a list
of the options installed. The options are separated from each other by means of commas.
Position Option
1 FSE-B3 TV Demodulator
2 FSE-B4 Low Phase Noise & OCXO
3 FSE-B5 FFT-Filter
4 reserved
5 FSE-B7 Vector Signal Analysis
6 FSE-B8 Tracking Generator 3.5 GHz
7 FSE-B9 Tracking Generator 3.5 GHz with I/Q modulator
8 FSE-B10 Tracking Generator 7 GHz
9 FSE-B11 Tracking Generator 7 GHz with I/Q modulator
10 FSE-B12 Output Attenuator for Tracking Generator
11 FSE-B13 1-dB Attenuator
12 reserved
13 FSE-B15 controller option
14 to 18 reserved
19 FSE-B21 External Mixer Output
20 to 21 reserved
22 FSE-B24 Frequency Extension to 44GHz
24 to 25 reserved
26 FSE-K10
GSM Test Software, Mobile
27 FSE-K11
GSM Test Software, Base Station
29 FSE-K20
GSM Test Software, Edge Mobile
30 FSE-K21
GSM Test Software, EDGE Base Station
31 FSE-K30
GSM Test Software, 850 GHz band Mobile
31 FSE-K31
GSM Test Software, 850 GHz band Base Station
Example: 0, FSE-B4, 0, 0, FSE-B7, 0, 0, 0, FSE-B11, FSE-B12, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0,..
*PCB 0 to 30
PASS CONTROL BACK indicates the controller address which the IEC-bus control is to be returned
to after termination of the triggered action.
*PRE 0 to 255
PARALLEL POLL REGISTER ENABLE sets parallel poll enable register to the value indicated.
Query *PRE? returns the contents of the parallel poll enable register in decimal form.
To Next Page
Loading...
