FSE CALCulate Subsystem
1065.6016.12 6.17 E-16
:CALCulate<1|2>:RLINe:STATe ON | OFF
This command switches the reference line on or off.
Example: ":CALC:RLIN:STAT ON"
Features: *RST value: OFF
SCPI: device-specific
Modes: A, VA, BTS, MS
:CALCulate<1|2>:FLINe<1|2> 0 GHz to f
max
This command defines the position of the frequency lines.
Example: ":CALC:FLIN2 120MHz"
Features: *RST value: - (STATe to OFF)
SCPI: device-specific
Modes: A-F, VA, BTS, MS
The frequency lines mark the given frequencies in the display. Frequency lines are only valid for a
SPAN >0.
:CALCulate<1|2>:FLINe<1|2>:STATe ON | OFF
This command switches the frequency line on or off.
Example: ":CALC:FLIN2:STAT ON"
Features: *RST value: OFF
SCPI: device-specific
Modes: A-F, VA, BTS, MS
:CALCulate<1|2>:TLINe<1|2> 0 to 1000s
This command defines the position of the time lines.
Example: ":CALC:TLIN 10ms"
Features: *RST value: - (STATe to OFF)
SCPI: device-specific
Modes: A-Z, VA, BTS, MS
The time lines mark the given times in the display. Time lines are only valid for a SPAN = 0.
:CALCulate<1|2>:TLINe<1|2>:STATe ON | OFF
This command switches the time line on or off.
Example: ":CALC:TLIN2:STAT ON"
Features: *RST value: OFF
SCPI: device-specific
Modes: A-Z, VA, BTS, MS
To Next Page
Loading...
