Rohde & Schwarz FSW-K40 - Page 119

Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
119User Manual 1173.9286.02 ─ 15
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Example:
DISP:TRAC2:SMO ON
Turns on trace smoothing for trace 2.
Manual operation: See "Traces" on page 54
DISPlay[:WINDow]:TRACe<t>:SMOothing:TYPE <Type>
This command selects the trace smoothing method.
Suffix:
<t>
.
Trace
Parameters:
<Type> LINear
Linear smoothing.
LOGarithmic
Logarithmic smoothing.
MEDian
Median smoothing.
*RST: LIN
Example:
DISP:TRAC2:SMO:TYPE LIN
Selects linear smoothing for trace 2.
Manual operation: See "Smoothing Type" on page 53
DISPlay[:WINDow]:TRACe<t>:SPURs:SUPPress <State>
This command turns spur suppression on individual traces on and off.
Suffix:
<t>
.
Trace
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Example:
DISP:TRAC3:SPUR:SUPP ON
Turns on spur suppression on trace 3.
Manual operation: See "Traces" on page 54
DISPlay[:WINDow]:TRACe:X[:SCALe]:HDECade <HalfDecade>
This command selects the half decade to be displayed.
Before you can use the command you have to select the half decade scope for the x-
axis with DISPlay[:WINDow]:TRACe:X[:SCALe]:SCOPe.
Graphical Display of Phase Noise Results