Rohde & Schwarz FSW-K40 - 8.12 Using Markers; Using Markers; Calculate<N>:Marker<M>:Aoff; Calculate<N>:Marker<M>[:State]

Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
139User Manual 1173.9286.02 ─ 15
Example:
FETC:PNO:SWE:STOP?
would return, e.g.:
3000,10000,30000,100000,300000
Usage: Query only
Manual operation: See "Sweep Result List" on page 18
8.12 Using Markers
The following commands are necessary to control markers.
● Using Markers.......................................................................................................139
● Using Delta Markers..............................................................................................141
● Configuring Markers..............................................................................................144
● Using the Marker Zoom.........................................................................................145
8.12.1 Using Markers
CALCulate<n>:MARKer<m>:AOFF..................................................................................139
CALCulate<n>:MARKer<m>[:STATe]...............................................................................139
CALCulate<n>:MARKer<m>:TRACe................................................................................140
CALCulate<n>:MARKer<m>:X........................................................................................ 140
CALCulate<n>:MARKer<m>:Y?.......................................................................................141
CALCulate<n>:MARKer<m>:AOFF
This command turns off all markers.
Suffix:
<n>
.
Window
<m> Marker
Example:
CALC:MARK:AOFF
Switches off all markers.
Usage: Event
Manual operation: See " All Marker Off " on page 66
CALCulate<n>:MARKer<m>[:STATe] <State>
This command turns markers on and off. If the corresponding marker number is cur-
rently active as a delta marker, it is turned into a normal marker.
Suffix:
<n>
.
Window
<m> Marker
Using Markers