Rohde & Schwarz FSW-K40 - Graphical Display of Phase Noise Results

Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
116User Manual 1173.9286.02 ─ 15
CALCulate<n>:LIMit<k>:UPPer[:DATA] <LimitLinePoints>
This command defines the vertical definition points of an upper limit line.
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<LimitLinePoints> Variable number of level values.
Note that the number of vertical values has to be the same as
the number of horizontal values set with CALCulate<n>:
LIMit<k>:CONTrol[:DATA]. If not, the R&S FSW either adds
missing values or ignores surplus values.
*RST: Limit line state is OFF
Manual operation: See "Data Points" on page 64
CALCulate<n>:LIMit<k>:UPPer:SHIFt <Distance>
This command moves a complete upper limit line vertically.
Compared to defining an offset, this command actually changes the limit line definition
points by the value you define.
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<Distance> Defines the distance that the limit line moves.
Usage: Event
Manual operation: See "Shift Y" on page 64
8.10 Graphical Display of Phase Noise Results
The following commands are necessary to set up and configure the graphical phase
noise result displays.
CALCulate<n>:MATH[:EXPression][:DEFine]....................................................................117
CALCulate<n>:MATH:STATe..........................................................................................117
DISPlay[:WINDow]:TRACe<t>:MODE.............................................................................. 118
DISPlay[:WINDow]:TRACe<t>:SMOothing:APERture........................................................ 118
DISPlay[:WINDow]:TRACe<t>:SMOothing[:STATe]...........................................................118
DISPlay[:WINDow]:TRACe<t>:SMOothing:TYPE.............................................................. 119
DISPlay[:WINDow]:TRACe<t>:SPURs:SUPPress..............................................................119
DISPlay[:WINDow]:TRACe:X[:SCALe]:HDECade.............................................................. 119
DISPlay[:WINDow]:TRACe:X[:SCALe]:SCOPe..................................................................120
DISPlay[:WINDow]:TRACe:X[:SCALe]:STARt................................................................... 120
Graphical Display of Phase Noise Results