Rohde & Schwarz FSW-K40 - Page 113

Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
113User Manual 1173.9286.02 ─ 15
CALCulate<n>:LIMit<k>:UPPer:STATe <State>
This command turns an upper limit line on and off.
Before you can use the command, you have to select a limit line with CALCulate<n>:
LIMit<k>:NAME on page 111.
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Manual operation: See "Visible" on page 61
8.9.3 Creating and Editing Standard Limit Lines
CALCulate<n>:LIMit<k>:COMMent..................................................................................113
CALCulate<n>:LIMit<k>:CONTrol[:DATA].........................................................................113
CALCulate<n>:LIMit<k>:CONTrol:SHIFt...........................................................................114
CALCulate<n>:LIMit<k>:LOWer[:DATA]........................................................................... 114
CALCulate<n>:LIMit<k>:LOWer:MODE............................................................................114
CALCulate<n>:LIMit<k>:LOWer:SHIFt............................................................................. 115
CALCulate<n>:LIMit<k>:UPPer:MODE.............................................................................115
CALCulate<n>:LIMit<k>:UPPer[:DATA]............................................................................116
CALCulate<n>:LIMit<k>:UPPer:SHIFt.............................................................................. 116
CALCulate<n>:LIMit<k>:COMMent <Comment>
This command defines a comment for a limit line.
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<Comment> String containing the description of the limit line.
Manual operation: See "Comment" on page 63
CALCulate<n>:LIMit<k>:CONTrol[:DATA] <LimitLinePoints>
This command defines the horizontal definition points of a limit line.
Suffix:
<n>
.
irrelevant
<k> Limit line
Using Limit Lines