Rohde & Schwarz FSW-K40 - Configuring In- and Outputs; Using the Marker Zoom

Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
145User Manual 1173.9286.02 ─ 15
8.12.4 Using the Marker Zoom
CALCulate:MARKer:FUNCtion:ZOOM..............................................................................145
DISPlay[:WINDow:]ZOOM[:STATe]..................................................................................145
CALCulate:MARKer:FUNCtion:ZOOM <ZoomFactor>
This command defines the factor or magnitude of the marker zoom.
Parameters:
<ZoomFactor> Range: 1 to 20
*RST: Zoom OFF
Example:
CALC:MARK:FUNC:ZOOM 12
Zooms into the diagram with a factor of 10 around marker 1.
Manual operation: See "Marker Zoom" on page 66
DISPlay[:WINDow:]ZOOM[:STATe] <State>
This command turns the marker zoom for marker 1 on and off.
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Example:
DISP:ZOOM ON
Turns on the marker zoom.
Manual operation: See "Marker Zoom" on page 66
8.13 Configuring In- and Outputs
The following commands are necessary to configure the frontend settings.
INPut:CONNector...........................................................................................................145
INPut:CONNector <ConnType>
Determines whether the RF input data is taken from the RF input connector or the
optional Analog Baseband I connector. This command is only available if the Analog
Baseband interface (R&S FSW-B71) is installed and active for input. It is not available
for the R&S FSW67 or R&S FSW85.
Parameters:
<ConnType> RF
RF input connector
AIQI
Analog Baseband I connector
*RST: RF
Configuring In- and Outputs