EasyManua.ls Logo

Rohde & Schwarz FSW-K40 - Using Markers

Rohde & Schwarz FSW-K40
166 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Analysis
R&S
®
FSW-K40
65User Manual 1173.9286.02 ─ 15
6.4 Using Markers
Access (marker position): MKR > "Marker Config" > "Markers"
Access (marker settings): MKR > "Marker Config" > "Marker Settings"
The "Marker Configuration" dialog box and the "Marker" menu contain all functionality
necessary to control markers.
The "Marker Configuration" dialog box consists of two tabs.
The "Markers" tab contains functionlity to define characteristics for each marker.
The "Marker Settings" tab contains general marker functionality.
Marker 1 ... Marker x.....................................................................................................65
Marker Type .................................................................................................................66
Reference Marker ........................................................................................................ 66
Assigning the Marker to a Trace .................................................................................. 66
Marker Zoom.................................................................................................................66
All Marker Off ............................................................................................................... 66
Marker Table Display ................................................................................................... 67
Marker Info ...................................................................................................................67
Marker 1 ... Marker x
Selects and turns the corresponding marker on and off.
Turning on a marker also opens an input field to define the horizontal position of the
marker.
In the "Marker Configuration" dialog box, you can also define the horizontal position of
each marker ("x-value").
By default, the first marker you turn on is a normal marker, all others are delta markers.
Remote command:
CALCulate<n>:MARKer<m>[:STATe] on page 139
CALCulate<n>:DELTamarker<m>[:STATe] on page 142
Using Markers

Table of Contents

Related product manuals