Rohde & Schwarz FSW-K40 - 8 Remote Control Commands for Phase Noise Measurements; Common Suffixes

Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
70User Manual 1173.9286.02 ─ 15
8 Remote Control Commands for Phase
Noise Measurements
The following remote control commands are required to configure and perform phase
noise measurements in a remote environment. The R&S FSW must already be set up
for remote operation in a network as described in the base unit manual.
Universal functionality
Note that basic tasks that are also performed in the base unit in the same way are not
described here. For a description of such tasks, see the R&S FSW User Manual.
In particular, this includes:
●
Managing Settings and Results, i.e. storing and loading settings and result data.
●
Basic instrument configuration, e.g. checking the system configuration, customizing
the screen layout, or configuring networks and remote operation.
●
Using the common status registers (specific status registers for Pulse measure-
ments are not used).
● Common Suffixes....................................................................................................70
● Introduction............................................................................................................. 71
● Controlling the Phase Noise Measurement Channel.............................................. 76
● Performing Measurements......................................................................................80
● Configuring the Result Display................................................................................85
● Configuring the Frontend........................................................................................ 92
● Controlling the Measurement..................................................................................95
● Configuring the Measurement Range..................................................................... 99
● Using Limit Lines...................................................................................................106
● Graphical Display of Phase Noise Results............................................................116
● Configure Numerical Result Displays....................................................................126
● Using Markers.......................................................................................................139
● Configuring In- and Outputs..................................................................................145
● Automatic Measurement Configuration.................................................................146
● Using the Status Register..................................................................................... 147
● Remote Control Example Scripts..........................................................................153
8.1 Common Suffixes
In the R&S FSW Phase Noise Measurement application, the following common suf-
fixes are used in remote commands:
Common Suffixes