How to Configure Phase Noise Measurements
R&S
®
FSW-K40
69User Manual 1173.9286.02 ─ 15
3. Select the "Sweep Type".
a) Select sweep types "Fast", "Normal" or "Averaged" for automatic measurement
configuration.
For a custom configuration, proceed to set up each measurement parameter sepa-
rately.
4. Define the "RBW", number of "Averages", sweep "Mode" and "I/Q Window" func-
tion.
a) Define the parameters globally for all (half) decades covered by the measure-
ment range.
b) Define the parameters for each individual (half) decade covered by the mea-
surement range in the "Half Decade Configuration Table".
Customizing the Measurement Range
To Next Page
Loading...
