Rohde & Schwarz FSW-K40 - Reading out Residual Noise Results

Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
129User Manual 1173.9286.02 ─ 15
8.11.2 Reading Out Residual Noise Results
FETCh:PNOise:IPN?......................................................................................................129
FETCh:PNOise<t>:RFM?................................................................................................129
FETCh:PNOise<t>:RMS?............................................................................................... 129
FETCh:PNOise<t>:RPM?............................................................................................... 129
FETCh:PNOise<t>:USER<range>:IPN?........................................................................... 130
FETCh:PNOise<t>:USER<range>:RFM?..........................................................................130
FETCh:PNOise<t>:USER<range>:RMS?......................................................................... 130
FETCh:PNOise<t>:USER<range>:RPM?......................................................................... 131
FETCh:PNOise:IPN?
This command queries the Integrated Phase Noise for the first trace.
Example:
FETC:PNO2:IPN?
Queries the Integrated Phase Noise for the first trace in the dia-
gram.
Usage: Query only
FETCh:PNOise<t>:RFM?
This command queries the residual FM for the first trace.
Suffix:
<t>
.
Trace
Example:
FETC:PNO2:RFM?
Queries the residual FM for the first trace in the diagram.
Usage: Query only
Manual operation: See "Residual Noise" on page 15
FETCh:PNOise<t>:RMS?
This command queries the residual RMS jitter for the first trace.
Suffix:
<t>
.
Trace
Example:
FETC:PNO2:RMS?
Queries the RMS jitter for the first trace in the diagram.
Usage: Query only
Manual operation: See "Residual Noise" on page 15
FETCh:PNOise<t>:RPM?
This command queries the residual PM for the first trace.
Configure Numerical Result Displays