Rohde & Schwarz FSW-K40 - Page 130

Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
130User Manual 1173.9286.02 ─ 15
Suffix:
<t>
.
Trace
Example:
FETC:PNO:RPM?
Queries the residual PM for the first trace of the diagram.
Usage: Query only
Manual operation: See "Residual Noise" on page 15
FETCh:PNOise<t>:USER<range>:IPN?
This command queries the Integrated Phase Noise for a particular user range.
The trace that is queried depends on CALCulate<n>:EVALuation:USER<range>:
TRACe.
Suffix:
<t>
.
Trace
<range> 1...3
Selects the user range.
Example:
FETC:PNO:USER2:IPN?
Queries the Integrated Phase Noise for user range 2.
Usage: Query only
FETCh:PNOise<t>:USER<range>:RFM?
This command queries the residual FM for a particular user range.
The trace that is queried depends on CALCulate<n>:EVALuation:USER<range>:
TRACe.
Suffix:
<t>
.
Trace
<range> 1...3
Selects the user range.
Example:
FETC:PNO:USER2:RFM?
Queries the residual FM for user range 2.
Usage: Query only
Manual operation: See "Residual Noise" on page 15
FETCh:PNOise<t>:USER<range>:RMS?
This command queries the residual RMS jitter for a particular user range.
The trace that is queried depends on CALCulate<n>:EVALuation:USER<range>:
TRACe.
Configure Numerical Result Displays