Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
99User Manual 1173.9286.02 ─ 15
Manual operation: See "AM Rejection" on page 42
[SENSe:]SWEep:SVFailed <State>
This command turns repeated tries to start the measurement if signal verification fails
on and off.
Parameters:
<State> ON | OFF | 1 | 0
If on, the application tries to verify the signal once and then
aborts the measurement if verification has failed.
*RST: 0
Example:
SWE:SVF ON
Stops the measurement if signal verification has failed.
Manual operation: See "On Verify Failed" on page 41
8.8 Configuring the Measurement Range
The following commands are necessary to configure the phase noise measurement
range.
Table 8-4: <range> suffix assignment
Suffix Half Decade
1 1 Hz ... 3 Hz
2 3 Hz ... 10 Hz
3 10 Hz ... 30 Hz
4 30 Hz ... 100 Hz
5 100 Hz ... 300 Hz
6 300 Hz ... 1 kHz
7 1 kHz ... 3 kHz
8 3 kHz ... 10 kHz
9 10 kHz ... 30 kHz
10 30 kHz ... 100 kHz
11 100 kHz ... 300 kHz
12 300 kHz ... 1 MHz
13 1 MHz ... 3 MHz
14 3 MHz ... 10 MHz
15 10 MHz ... 30 MHz
16 30 MHz ... 100 MHz
Configuring the Measurement Range
To Next Page
Loading...
