Rohde & Schwarz FSW-K40 - Page 100

Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
100User Manual 1173.9286.02 ─ 15
Suffix Half Decade
17 100 MHz ... 300 MHz
18 300 MHz ... 1 GHz
19 1 GHz ... 3 GHz
20 3 GHz ... 10 GHz
[SENSe:]LIST:BWIDth[:RESolution]:RATio....................................................................... 100
[SENSe:]BANDwidth|BWIDth[:RESolution]:TYPE.............................................................. 100
[SENSe:]FREQuency:STARt...........................................................................................101
[SENSe:]FREQuency:STOP............................................................................................101
[SENSe:]LIST:BWIDth:RESolution:TYPE..........................................................................101
[SENSe]:LIST:IQWindow:TYPE.......................................................................................102
[SENSe:]LIST:RANGe<range>:BWIDth[:RESolution].........................................................102
[SENSe:]LIST:RANGe<range>:FILTer:TYPE.................................................................... 103
[SENSe:]LIST:RANGe<range>:IQWindow:TYPE...............................................................103
[SENSe:]LIST:RANGe<range>:SWEep:COUNt.................................................................104
[SENSe:]LIST:SWEep:COUNt.........................................................................................104
[SENSe:]LIST:SWEep:COUNt:MULTiplier........................................................................ 104
[SENSe:]LIST:SWEep:COUNt:MULTiplier:STATe............................................................. 105
[SENSe:]SWEep:FORWard............................................................................................ 105
[SENSe:]SWEep:MODE................................................................................................. 105
[SENSe:]LIST:BWIDth[:RESolution]:RATio <Ratio>
This command defines the resolution bandwidth over all half decades.
Parameters:
<Ratio> Numeric value in %.
The resulting RBW is the percentage of the start frequency of
each half decade.
If the resulting RBW is not available, the application rounds to
the next available bandwidth.
Range: 1 to 100
*RST: 10
Example:
LIST:BWID:RAT 20
Defines a RBW of 20% of the start frequency of the correspond-
ing half decade.
Manual operation: See "Global RBW" on page 44
[SENSe:]BANDwidth|BWIDth[:RESolution]:TYPE <Mode>
This command selects the sweep mode for a all half decades globally.
Configuring the Measurement Range