Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
147User Manual 1173.9286.02 ─ 15
Usage: Event
Manual operation: See " Setting the Reference Level Automatically ( Auto Level )"
on page 49
8.15 Using the Status Register
The status reporting system stores information about the current state of the
R&S FSW. This includes, for example, information about errors during operation or
information about limit checks. The R&S FSW stores this information in the status reg-
isters and in the error queue. You can query the status register and error queue via
IEC bus.
The R&S FSW-K40 features several status registers that are specific to phase noise
measurements. Here is a description of those, including the corresponding remote
commands.
● Status Registers for Phase Noise Measurements................................................ 147
8.15.1 Status Registers for Phase Noise Measurements
The figure below shows the status registers of the phase noise application.
Using the Status Register
To Next Page
Loading...
