Analysis
R&S
®
FSW-K40
54User Manual 1173.9286.02 ─ 15
"Median"
Smoothes the trace based on the median value of the sample.
Remote command:
DISPlay[:WINDow]:TRACe<t>:SMOothing:TYPE on page 119
Trace Config
Opens a dialog box to configure traces.
The application supports up to 6 traces with a different setup. In the diagram each
trace has a different color.
The diagram header of the measurement window contains the trace information,
including a color map, trace mode and smoothing percentage.
Note that trace configuration is also possible in the "Trace" softkey menu available via
the TRACE key.
Traces ← Trace Config
The "Traces" tab contains functionality to configure a trace.
"Trace Selec-
tion"
The "Trace 1" to "Trace 6" buttons select a trace. If a trace is
selected, it is highlighted orange.
Note that you cannot select a trace if its trace mode is "Blank".
"Trace Mode"
Selects the trace mode for the corresponding trace.
For more information see Chapter 4.10, "Analyzing Several Traces -
Trace Mode", on page 33.
"Smoothing"
Turns trace smoothing for the corresponding trace on and off.
For each trace, the application allows you to select the smoothing
type and percentage.
For more information see Chapter 4.5.3, "Trace Smoothing",
on page 26 (➙ "Graphical" tab).
"Spur
Removal"
Turns spur removal on a particular trace on and off.
You can define a threshold above which a spur is detected with the
Threshold parameter.
For more information see Chapter 4.1, "Spurs and Spur Removal",
on page 22.
Remote command:
Trace mode: DISPlay[:WINDow]:TRACe<t>:MODE on page 118
Trace smoothing: DISPlay[:WINDow]:TRACe<t>:SMOothing[:STATe]
on page 118
Spur removal: DISPlay[:WINDow]:TRACe<t>:SPURs:SUPPress on page 119
Quick Config ← Trace Config
Commonly required trace settings have been predefined and can be applied very
quickly by selecting the appropriate button.
Configuring Graphical Result Displays
To Next Page
Loading...
