Rohde & Schwarz FSW-K40 - Configuring Spot Noise Measurements

Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
131User Manual 1173.9286.02 ─ 15
Suffix:
<t>
.
Trace
<range> 1...3
Selects the user range.
Example:
FETC:PNO:USER2:RMS?
Queries the RMS jitter for user range 2.
Usage: Query only
Manual operation: See "Residual Noise" on page 15
FETCh:PNOise<t>:USER<range>:RPM?
This command queries the residual PM for a particular user range.
The trace that is queried depends on CALCulate<n>:EVALuation:USER<range>:
TRACe.
Suffix:
<t>
.
Trace
<range> 1...3
Selects the user range.
Example:
FETC:PNO:USER2:RPM?
Queries the residual PM for user range 2.
Usage: Query only
Manual operation: See "Residual Noise" on page 15
8.11.3 Configuring Spot Noise Measurements
CALCulate<n>:SNOise:AOFF......................................................................................... 131
CALCulate<n>:SNOise:DECades[:STATe]....................................................................... 132
CALCulate<n>:SNOise:DECades:X?............................................................................... 132
CALCulate<n>:SNOise:DECades:Y?............................................................................... 132
CALCulate<n>:SNOise<m>:STATe................................................................................. 133
CALCulate<n>:SNOise<m>:X......................................................................................... 133
CALCulate<n>:SNOise<m>:Y?........................................................................................134
DISPlay[:WINDow<n>]:TRACe<t>:SELect........................................................................134
CALCulate<n>:SNOise:AOFF
This command turns all spot noise markers off (custom and 10
x
markers).
Suffix:
<n>
.
Window
Example:
CALC:SNO:AOFF
Turns all spot noise markers off.
Usage: Event
Configure Numerical Result Displays