Rohde & Schwarz FSW-K40 - Configuring In- and Outputs

Configuration
R&S
®
FSW-K40
48User Manual 1173.9286.02 ─ 15
If the trace modes "Average" , "Max Hold" or "Min Hold" are set, this value also deter-
mines the number of averaging or maximum search procedures.
In continuous sweep mode, if "Sweep Count" = 0 (default), averaging is performed
over 10 sweeps. For "Sweep Count" =1, no averaging, maxhold or minhold operations
are performed.
Remote command:
[SENSe:]SWEep:COUNt on page 84
Finish Half Decade
Aborts the measurement in the current half decade and continues measuring the sub-
sequent half decade.
Averaged results displayed for a half decade finished prematurely are based on the
number of measurements already done.
Remote command:
[SENSe:]SWEep:FHDecade on page 84
5.7 Configuring In- and Outputs
The "In- / Output" menu contains all functionality necessary to control and perform
phase noise measurements.
The R&S FSW Phase Noise Measurement application can also process input from an
external mixer. For details on configuring the external mixer see the manual of the
R&S FSW.
● Input Source Configuration..................................................................................... 48
5.7.1 Input Source Configuration
Access: "Overview" > "Input / Frontend" > "Input Source Config"
The "Radio Frequency" dialog box contains functionality to configure the input source.
Note that the "Radio Frequency (On Off)" button is unavailable in the R&S FSW-K40
Coupling........................................................................................................................48
Input Connector.............................................................................................................49
Coupling
Selects the coupling method at the RF input.
AC coupling blocks any DC voltage from the input signal. DC coupling lets DC voltage
through.
For more information refer to the data sheet.
Remote command:
INPut:COUPling on page 94
Configuring In- and Outputs