Rohde & Schwarz FSW-K40 - 6.1.2 Configuring Traces; Smoothing Type; Trace Offset; Trace Smoothing

Analysis
R&S
®
FSW-K40
53User Manual 1173.9286.02 ─ 15
Remote command:
Top:
DISPlay[:WINDow]:TRACe:Y[:SCALe]:RLEVel on page 122
Range:
DISPlay[:WINDow]:TRACe:Y:[:SCALe] on page 121
Bottom:
DISPlay[:WINDow]:TRACe:Y[:SCALe]:RLEVel:LOWer on page 122
Auto Scale Once
Automatically scales the vertical axis for ideal viewing.
6.1.2 Configuring Traces
Trace Offset.................................................................................................................. 53
Trace Smoothing...........................................................................................................53
Smoothing Type............................................................................................................53
Trace Config..................................................................................................................54
└ Traces.............................................................................................................54
└ Quick Config................................................................................................... 54
└ Trace Export................................................................................................... 55
└ Copy Trace .................................................................................................... 55
└ Trace Math......................................................................................................56
Spur Removal / Spur Threshold....................................................................................56
Frequency Drift: Trace 1 (On Off)................................................................................. 56
Spectrum Monitor: Raw Trace / Trk Trace (On Off)...................................................... 56
Trace Offset
Defines a trace offset in dB.
The trace offset moves the trace vertically by the level you have defined.
The range is from -200 dB to 200 dB.
Remote command:
DISPlay[:WINDow]:TRACe:Y[:SCALe]:RLEVel:OFFSet on page 123
Trace Smoothing
Defines the magnitude (or aperture) of trace smoothing in percent.
The range is from 1% to 20%. The aperture takes effect on all traces that you smooth.
For more information see Chapter 4.5.3, "Trace Smoothing", on page 26.
Remote command:
DISPlay[:WINDow]:TRACe<t>:SMOothing:APERture on page 118
Smoothing Type
Selects the method that the application uses to smooth the trace.
For more information see Chapter 4.5.3, "Trace Smoothing", on page 26.
"Linear"
Converts the data to linear values before smoothing the trace.
"Logarithmic"
Smoothes the (original) logarithmic data.
Configuring Graphical Result Displays