Rohde & Schwarz FSW-K40 - Page 66

Analysis
R&S
®
FSW-K40
66User Manual 1173.9286.02 ─ 15
Marker Type
Toggles the marker type.
The type for marker 1 is always "Normal" , the type for delta marker 1 is always "Delta
" . These types cannot be changed.
Note: If normal marker 1 is the active marker, switching the "Mkr Type" activates an
additional delta marker 1. For any other marker, switching the marker type does not
activate an additional marker, it only switches the type of the selected marker.
"Normal"
A normal marker indicates the absolute value at the defined position
in the diagram.
"Delta "
A delta marker defines the value of the marker relative to the speci-
fied reference marker (marker 1 by default).
Remote command:
CALCulate<n>:MARKer<m>[:STATe] on page 139
CALCulate<n>:DELTamarker<m>[:STATe] on page 142
Reference Marker
Defines a marker as the reference marker which is used to determine relative analysis
results (delta marker values).
Remote command:
CALCulate<n>:DELTamarker<m>:MREFerence on page 142
Assigning the Marker to a Trace
The "Trace" setting assigns the selected marker to an active trace. The trace deter-
mines which value the marker shows at the marker position. If the marker was previ-
ously assigned to a different trace, the marker remains on the previous frequency or
time, but indicates the value of the new trace.
If a trace is turned off, the assigned markers and marker functions are also deactiva-
ted.
Remote command:
CALCulate<n>:MARKer<m>:TRACe on page 140
Marker Zoom
Turns the marker zoom on and off.
The marker zoom magnifies the diagram area around marker 1 by a certain factor.
Turning on the zoom also opens an input field to define the zoom factor.
Remote command:
Turning on the zoom:
DISPlay[:WINDow:]ZOOM[:STATe] on page 145
Defining the zoom factor:
CALCulate:MARKer:FUNCtion:ZOOM on page 145
All Marker Off
Deactivates all markers in one step.
Remote command:
CALCulate<n>:MARKer<m>:AOFF on page 139
Using Markers