Rohde & Schwarz FSW-K40 - Page 117

Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
117User Manual 1173.9286.02 ─ 15
DISPlay[:WINDow]:TRACe:X[:SCALe]:STOP....................................................................121
DISPlay[:WINDow]:TRACe:Y:[:SCALe].............................................................................121
DISPlay[:WINDow]:TRACe:Y[:SCALe]:AUTO....................................................................121
DISPlay[:WINDow]:TRACe:Y[:SCALe]:MANual................................................................. 122
DISPlay[:WINDow]:TRACe:Y[:SCALe]:RLEVel..................................................................122
DISPlay[:WINDow]:TRACe:Y[:SCALe]:RLEVel:LOWer...................................................... 122
DISPlay[:WINDow]:TRACe:Y[:SCALe]:RLEVel:OFFSet..................................................... 123
FORMat:DEXPort:DSEParator........................................................................................ 123
FORMat:DEXPort:HEADer..............................................................................................123
FORMat:DEXPort:TRACes............................................................................................. 123
MMEMory:STORe<n>:TRACe.........................................................................................124
[SENSe:]SPURs:SUPPression........................................................................................ 124
[SENSe:]SPURs:THReshold........................................................................................... 125
TRACe<n>:COPY..........................................................................................................125
TRACe[:DATA]?............................................................................................................ 125
CALCulate<n>:MATH[:EXPression][:DEFine] <Expression>
This command selects the mathematical expression for trace mathematics.
Before you can use the command, you have to turn trace mathematics on.
Suffix:
<n>
.
Window
Parameters:
<Expression> (TRACE1-TRACE2)
Subtracts trace 2 from trace 1.
(TRACE1-TRACE3)
Subtracts trace 3 from trace 1.
(TRACE1-TRACE4)
Subtracts trace 4 from trace 1.
Example:
CALC:MATH:STAT ON
Turns trace mathematics on.
CALC:MATH:EXPR:DEF (TRACE1-TRACE3)
Subtracts trace 3 from trace 1.
Manual operation: See "Trace Math" on page 56
CALCulate<n>:MATH:STATe <State>
This command turns the trace mathematics on and off.
Suffix:
<n>
.
Window
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Example:
CALC:MATH:STAT ON
Turns on trace mathematics.
Graphical Display of Phase Noise Results