Rohde & Schwarz FSW-K40 - Page 4

Contents
R&S
®
FSW-K40
4User Manual 1173.9286.02 ─ 15
6.1 Configuring Graphical Result Displays.................................................................... 51
6.2 Configure Numerical Result Displays....................................................................... 56
6.3 Using Limit Lines........................................................................................................ 58
6.4 Using Markers............................................................................................................. 65
7 How to Configure Phase Noise Measurements.................................68
7.1 Performing a Basic Phase Noise Measurement.......................................................68
7.2 Customizing the Measurement Range...................................................................... 68
8 Remote Control Commands for Phase Noise Measurements......... 70
8.1 Common Suffixes........................................................................................................70
8.2 Introduction................................................................................................................. 71
8.3 Controlling the Phase Noise Measurement Channel...............................................76
8.4 Performing Measurements.........................................................................................80
8.5 Configuring the Result Display..................................................................................85
8.6 Configuring the Frontend...........................................................................................92
8.7 Controlling the Measurement.................................................................................... 95
8.8 Configuring the Measurement Range....................................................................... 99
8.9 Using Limit Lines...................................................................................................... 106
8.10 Graphical Display of Phase Noise Results............................................................. 116
8.11 Configure Numerical Result Displays..................................................................... 126
8.12 Using Markers........................................................................................................... 139
8.13 Configuring In- and Outputs.................................................................................... 145
8.14 Automatic Measurement Configuration..................................................................146
8.15 Using the Status Register........................................................................................ 147
8.16 Remote Control Example Scripts............................................................................ 153
List of Remote Commands (Phase Noise).......................................159
Index....................................................................................................164