Rohde & Schwarz SMB100A - Page 172

R&S SMB Troubleshooting
1407.0806.82 3.33 E-6
Pin at X108
Test Point
(
Basis Board)
Remark
13 STEREO_MPX Analog Stereo multiplex signal to rf-board
11 LF_STEREO Analog modulation signal from rf-board
Note: Wire 1 (marked red) of the ribbon cable is connected to pin 34 of X108!
Fig. 3-9 Pin location X108 on Basis Board
Pin 11
Pin 13