Rohde & Schwarz SMB100A - Installing the Stereo;Rds-Coder

R&S SMB Module Replacement
1407.0806.82 3.59 E-6
 Unlock the four combination screws on the RDS Stereo Coder Board and remove the holding plate
(
1406.6269.00).
Installing the Stereo/RDS-Coder
 Screw the RDS Stereo-Coder with the holding plate (1406.6269.00) using four combination screws
(1148.3059.00), see.
 Connect the three RF-Cables W401 to W403 (1407.3334.00) with the nuts at the back of the
R&S SMB-Frame.